Qmark HT Smart Series - Digital Programmable Wall Heater Instrukcja Użytkownika Pobierz pdf (Strona 5)

MAINTENANCE

Your heater is designed for years of trouble-free operation and

requires no special maintenance other than occasional cleaning.

The motor is permanently lubricated.

Cleaning

Once each year, the heater should be cleaned to remove dust

and other foreign material which has collected during the heat-

ing season, as follows:

1. Turn power off at main switch.

2. Remove bottom bezel and the two screws that hold the grille.

3. Use vacuum cleaner with brush attachment to remove dust

and dirt that has accumulated in heater (especially around

element and blower blade). Do not use water or any cleaners

to clean heater components.

4. Replace grille and bottom bezel.

5. Wipe grille clean with a damp cloth. DO NOT use waxes or

any cleaners that leave a residue since these may discolor

during heater operation.

6. Turn the main line switch on at the switch panel to restore

power to heater. The heater is now ready for another season

of operation.

ALL OTHER SERVICING SHOULD BE PERFORMED BY AN

ELECTRICIAN OR QUALIFIED PERSON

Ref Part Number

No. Description 120V 240V

1. Grille panel only 2501-11003-000 2501-11003-000

2. Electronic Assembly 1016-11035-001 1016-11035-001

with top bezel

3. Motherboard, triac/heat sink, ribbon connector, 1414-11007-000 1414-11007-001

and sensor assembly (in one box):

4. Bottom bezel 1219-11004-000 1219-11004-000

5. Motor assembly 1225-11001-000 1225-11001-001

6. Manual Reset 4520-11005-000 4520-11005-000

7. Heating Element 302023802 302023805

8. Red lamp 3510-2017-000 3510-2017-001

9. Remote Control 1414-11017-000 1414-11017-000

10 Battery 1218-11003-000 1218-11003-000

REPAIR PARTS

Repair Parts List

1 2 3 4 5 6 7 8 9 10 ... 19 20

Brak uwag

Qmark HT Smart Series - Digital Programmable Wall Heater Instrukcja Użytkownika Strona 5